REXROTH IndraDrive C - Page 301

Rexroth IndraDrive Index 20-5
DOK-INDRV*-SYSTEM*****-PR02-EN-P
mains filters for AC drives 7-25
mains filters for drive controllers HCS02 8-11
mains filters for drive controllers HCS03 8-13
mains frequency tolerance 10-7
mains harmonics 15-11
mains short-circuit power 10-3
mains transformers 4-1
mains types 10-1
mains voltage harmonics 10-13
mains voltage unbalance 10-7
mains-side continuous current 8-6
Materials
of products 17-2
maximum allowed mains overvoltages 10-9
maximum connected load 10-5
measures to reduce noise emission 8-6
metal surfaces 7-32
minimum capacitance against ground 6-2
minimum distance 7-5
minimum distance for ventilation 7-6
minimum distance to braking resistor 7-7
minimum distance to mounting parts 7-7
modular 1-11
modular inverters 1-11
module bus connection X1 12-10
module bus connections 14-60
moisture condensation 7-19
motor
replace 16-2
motor cable
shield connection 14-42
motor cable length
length of motor power cable 5-9
motor encoder system 6-20
motor filter HMF01
assignment to HCS03 6-18
motor filters HMF01 6-18
motor power cable 7-21
motor power cables 6-22
mounting depth 7-3
mounting depth adapter 14-45
mounting position 7-1
mounting positions 7-1
mounting RKB bus cable 14-61
N
noise emission of the drive systems 8-6
nominal current of supply mains 8-5
normal mounting position 7-1
O
operating conditions 5-4
operating principle 11-3
overview of accessories 14-1
P
Packaging
materials 17-1
peak regenerative power
calculate 15-9
performance-dependent arrangement 7-20
PFC 10-5
point of connection for equipment grounding conductor 7-25
position of system connections 12-2
power dissipation
calculation to reduce generated power dissipation 15-6
power factor correction 10-5