6118 [Jogger Off/On]
This SP switches the jogging operation of the output jogger unit attached to the side of the
finisher off and on.
[0~1/0/1] 0: Off, 1: On
Note: After installation of the Output Jogger Unit B703, this SP must be set to "1" for the
jogging motor to operate the jogging fences.
6119 [Thick Paper Punch] Punch Function Enabled (Thick Paper)
Allows punching heavier paper, including tab sheets.
[0~1/1]
0: Punching thick paper prohibited
1: Punching thick paper allowed
6120 [Finisher Free Run] Finisher Free Run (B706)
Selects the free run mode during testing.
001 Free Run 1 Stapling Mode Stapling only
002 Free Run 2 All Mode All finisher operation is tested
003 Free Run 3 Packing Mode
Before you move the finisher to a new location, do this
SP. When you switch on the machine after you moved
it, the finisher automatically goes to the ready condition.
004 Free Run 4 Shift Mode Tests the shift mode
6121 [Input C Fin 1] Finisher Input Check: Finisher 1 (Finisher B700)
Displays the signals received from sensors and switches of the finisher. See "Finisher 1 Input
Check: SP6121"
6122 [Input C Fin 2] Finisher Input Check: Finisher 2 (Finisher B703)
Displays the signals received from sensors and switches of the finisher. See " Finisher 2 Input
Check: SP6122"
6124 [Output C Fin 1] Finisher Output Check: Finisher 1 (Finisher B700)
Service Program Mode Tables
381
To Next Page
