Ricoh MT-P2 - Page 84

5. Pull out the jogger unit [1].
6. Remove the tapes and retainers.
Docking the Finisher
1. If you are not installing the Cover Interposer B704, peel the strip from the sponge cushion
[1] and attach it to the finisher then go to the next step.
If you are installing the Cover Interposer B704:
• Do not attach the sponge cushion to the finisher. It must be attached to the cover interposer.
• Do not attach the grounding plate [2] to the finisher. It must be attached to the cover interposer.
• Install the interposer now. The cover interposer must be installed before you dock the finisher to
the machine.
2. Use a short screwdriver to attach the grounding plate [2] ( x 2, M3 x 6).
2000-Sheet Finisher (B700)
83
1