Chapter 11 Troubleshooting
164
F10 Page Format is Larger
than Paper Size
!! Possible Ink Smudges on
Prints !!
(Continue->PROOF Key)
The paper that is currently set is smaller than the size of the master
that has been made.
Check the size of the paper and set an appropriate paper.
To continue outputting the proof copies, press the [PROOF] key.
F28 The Paper Feed Setting
Lever is set to "CARD".
Check if the setting is
consistent with paper
in the Standard
Feed Tray.
This screen is displayed when the paper feed setting lever is set to the
position of [CARD] while [Paper Feed Adj.] (A 82) is set to [Auto].
Check the paper to be used, and then switch the position of the paper
feed setting lever (A 32) as necessary.
F32 !! The Data Storage Area
has Become Full !!
Clear Old Storage Data
Touch [Storage], and then delete any of the unnecessary original data.
F33 The file size is too large
to store on USB flash drive
Change the USB flash drive
or delete some files
to make spaces
Touch [USB Job List], and then delete any of the unnecessary original
data.
F34 !! The Number of Storage
Data has Become Full !!
Clear Old Storage Data
in the Selected Folder
Touch [Storage], and then delete any of the unnecessary original data.
F51 INK
Near expiration
Use or replace soon
In order to use the ink cartridge under optimal conditions, use it within
approximately 24 months after its manufacture date.
F56 MASTER
Near expiration
Use or replace soon
In order to use the master roll under optimal conditions, use it within
approximately 24 months after its manufacture date.
F57 INK & MASTER
Near expiration
Use or replace soon
In order to use the ink cartridge and the master roll under optimal con-
ditions, use them within approximately 24 months after their manufac-
ture date.
F65 Auto Page Size Selection
is Not Available for
Irregular-Size Original
Select Format Size to Store
and then Restart
When a custom size original is currently set in place, touch [Format]
(A 113), and then specify the size of the data to be saved.
If the position of the original is shifted, set it back to the correct position.
F74 Printer Temperature is Low
Specified Print Speed is Not
Available
[160ppm] and [190ppm] are available when the temperature in the print
drum (cylinder) is as follows.
• [160ppm]: 5°C (41°F) or higher
• [190ppm]: 15°C (59°F) or higher
If the print drum (cylinder) is cool, increase the room temperature or
print at speed [5] for a while, and wait until the print drum (cylinder) is
sufficiently warm.
Code Message Action
To Next Page
Loading...
