Riso SF9490 - Page 167

Chapter 11 Troubleshooting
165
11
F85 ! Scanning is Not Possible !
External Controller is not Con-
nected
or Processing Connection
Check Cable Connection
Check that the optional RISO Controller IS300 is connected correctly.
If the RISO Controller IS300 is not connected, set [External Controller]
(A 120) in [Admin.] to [OFF].
F93 Check the Settings
The Selected Reproduction
Ratio will not fit the
Max. Printing Area
Touch [Size] (A 57), and then change the magnification rate.
You can also touch [Continue] without changing the magnification rate.
However, a complete image may not be printed in this case, because
the area outside “master making area” (A 17) is not included in master
making.
F94
F95
-- Protect --
Discard Current Master
Touch [OK] to perform [Confidential] (A 99).
(A 135 “Managing the Used Master [Protect]”)
F96 Please inform this message
to your administrator
Due date for
ID counter report
Please contact your administrator to announce that the ID counter
report day has arrived.
BUntil [Report Output] (A 102) is performed, a warning screen
is displayed whenever the power turns on. If you do not want
to perform [Report Output] for the current month, touch [Stop
Reminder] under [ID Counter Report] (A 102).
G02
Decoding Paper Memory Print failed
Check the position of the original
If the Paper Memory Original is not placed straight on the glass platen,
it may not be scanned properly.
Place the Paper Memory Original again.
If the glass platen or platen cover pad is stained, the Paper Memory
Original may not be scanned properly.
Clean the glass platen and retry scanning the Paper Memory Original.
(A 157 “Glass platen and platen cover pad”)
If the Paper Memory Original is stained, wrinkled, or creased, or if the
Paper Memory Original has writing in an undesignated area (A 73),
this machine may not be able to properly scan the Paper Memory Orig-
inal.
We advise that the Paper Memory Original be printed again on a clean
sheet of paper.
G03 The original is incorrect
Set the following original
Check the header section of the Paper Memory Original. Place the
Paper Memory Original that corresponds with the information that is
displayed in the error screen.
Code Message Action