DISPLAY PANEL MANUAL
5-57
●Load setting value from the USB flash drive
The following screen will be displayed when the Read from USB Memory is chosen from the USB
MEMORY menu. Press OK or Cancel key. Press Cancel to abort and return to the USB MEMORY
menu. Press OK to load setting values by procedure from 1) to 5).
Setting values will load to connecting Multi-Controller and DR.
1) Confirm window to execute 2) Access to the USB-A PORT
3) Erase data of the backup memory 4) Save setting values to the backup memory
5) Load from the USB flash drive
Figure 5.6-9 Load setting values to the USB flash drive
To Next Page