DISPLAY PANEL MANUAL
12-3
●Warning messages
MESSAGE CAUSE REMEDY
“DR not connected”
The NUTRUNNER you are trying to
access is not connected.
Check connection of the
NUTRUNNER.
“Write Error”
The NUTRUNNER you are trying to
program is not set in the Write Mode.
Enable the Write Mode of the
NUTRUNNER.
Fastening settings or Maintenance
are operated by other unit (UIT etc.).
Confirm the usage of other
connecting unit.
“On Maintenance Mode”
“Operation invalid”
Turn off while Fastening settings or
Maintenance are operated by setting
unit (DISPLAY PANEL or USER
INTER FACE TERMINAL).
Turn off and turn on again.
“BATTERY LOW”
The Coin-type Lithium battery voltage
is lowered.
Replace the battery.
Table 12.1-2 Warning messages of the DISPLAY PANEL
To Next Page