Sanyo SDNR - Page 208

12. Trouble shooting
12-4
●Error messages
MESSAGE CAUSE REMEDY
ARCNET Communication
Internal self-diagnosis Error
Problem self-detection by the IC
DISPLAY PANEL may be defective.
Contact our company.
ARCNET Communication
Duplicate ID Error
The unit of identical No. exists
in the network.
Check No. of each unit.
ARCNET Communication
NAK Trouble
Transmission did not succeed.
Contact our company and inform us
about environment of the
NUTRUNNER.
ARCNET Communication
TIME UP Trouble
Transmission did not succeed.
Contact our company and inform us
about environmen
t of the
NUTRUNNER.
ARCNET Communication
Send Trouble
Transmission did not succeed.
Contact our company and inform us
about environment of the
NUTRUNNER.
My Reconfiguration
Reconfiguration
A unit was removed from or
added to the network.
Check whether recycling the powe
r to
any unit occurred
after the network
was established. Confirm the
environment (noise etc.).
ARCNET Communication
Receive Trouble
Reception of data from the
DRIVER did not succeed.
Contact our company and inform us
about environment
of the
NUTRUNNER.
ARCNET Communication
Network Trouble
A trouble occurred
in the
network.
Check the connection, configuration
etc. of the unit.
ARCNET Communication
Write Address Invalid
The address you are trying to
write is prohibited.
Check the using conditions.
ARCNET Communication
Receive Overflow
Reception buffer overflow. Check the using conditions.
BATTERY ERROR
The Coin-type Lithium
battery
voltage is not connected.
Connect the battery.
Table 12.1-3 Error messages of the DISPLAY PANEL