SATO s86ex - ESC+BT Registration of Bar Width Ratio

100
62.1 Barcode
62.1 ESC+BT Registration of Bar Width
Ratio
ESC+BT
Hexadecimal
code
ESC
BT
Parameter
<1B>
16
<42>
16
<54>
16
abbccddee
Initial value
Nil
Valid range and
term of
command
When the power switch is OFF
The set parameter is not maintained.
Valid range within item
The set parameter is in effect until a new specification is made.
Valid range between item
The set parameter is in effect until a new specification is made.
[Function]
Specifying the bar width ratio of narrow and wide bars.
[Format]
<BT>abbccddee
●Parameter
a[Barcode symbology] = 0 : CODABAR(NW-7)
1 : CODE39
2 : ITF
5 : Industrial 2 of 5
6 : Matrix 2 of 5
b[Narrow space] = Valid range : 01 to 99 dots
c[Wide space] = Valid range : 01 to 99 dots
d[Narrow bar ] = Valid range : 01 to 99 dots
e[Wide bar] = Valid range : 01 to 99 dots
[Coding Example] Barcode symbology : CODE39 Narrow space : 03 Wide space : 05
Narrow bar : 03 Wide bar : 05
<A>
<BT>103050305
<V>100<H>200<BW>01233*ABCD*
<Q>2
<Z>
[Notes]
1. To print barcode with specified ratio, insert Print of Barcode with Registered Ratio <BW> after this command.
2. When <BW> and Print Quantity <Q> are not specified, only the registration of bar width ratio of narrow and wide bars will be
performed.
3. Only one ratio can be registered.
4. If the data other than specified is set, this will not be registered due to command error.
Registration of Bar Width Ratio