251
ESC+T2 Memory card 24×24 dots
External Font Registration
Valid range and
term of
command
When the power switch is OFF
The registered data becomes valid.
The parameter preset will be invalid.
The parameter preset will be invalid.
[Function]
Register 24x24 dots external characters to the memory card.
[Format]
<T2>abbn~n
●Parameter
a[Select register data type] = H : HEX character
B : Binary code
b[Register font code address] = H : in the range from “21” to “7F”, up to 95 items can be registered
B : in the range from 21H to 7FH, up to 95 items can be registered
n [External character registration data]
[Coding Example]
<A>
<CC>1
<T2>H2100FF00FF~3C0000FF
<Q>2
<Z>
[Notes]
1. It is possible to overwrite the data that is registered once.
2. Make sure to specify the slot number used for card slot command <CC> before the memory card 24x24 external character
registration command <T2>.
3. The error may occur when other registration command and the memory card 24x24 external character registration command
<T2> at the same time due to not enough memory in the memory card. As a countermeasure, register other registration to
another memory card or use a memory card that has more capacity.
4. The output order of the data is as follows.
5. The error occurs when unused or the slot which the printer is allocated is specified (Refer to Card Slot for Use <CC>).
External file [24x24]
When registering the above external character, D1 data are <00>
16
, D2 data are <3C>
16
, D3 data are <00>16 because the
constitution of D1 is [00000000], D2 is [00111100] and D3 is [00000000].
In the same manner, D4 is <00>
16
, D5 is <3C>
16
, D6 is <00>
16
, and the external registration data will be <003C00003C00.....>
16
up to D72.
Memory card 24x24 dots
External Font Registration
To Next Page
Loading...
