SATO s86ex - ESC+A3 Base Offset Setting

216
b
d
Base point after
Base point before
Media feed
12.4 System
ESC+A3 Base Offset Setting
12.4
ESC+A3
Hexadecimal
code
ESC
A3
Parameter
<1B>
16
<41>
16
<33>
16
VabbbHcddd
Initial value
a=+､b=000､c=+､d=000
Valid range and
term of
command
When the power switch is OFF
The set parameter is maintained.
Valid range within item
The set parameter is in effect until a new specification is made.
Valid range between item
The set parameter is in effect until a new specification is made.
[Function]
Changes the coordinate of the base point. This is configured in the advanced mode of the printer normally.
[Format]
<A3>VabbbHcddd
●Parameter
a[Vertical offset code] (Omissible) = +, -
b[Vertical offset (in dot)] = Refer to the below table
c[Horizontal offset code] (Omissible) = +, -
d[Horizontal offset (in dot)] = Refer to the below table
[Coding Example]
<A>
<A3>V10H10
<Z>
[Notes]
1. Note that when the base point is offset and the image is out of the printable area, the image may not be printed.
2. Note that when offset the base point while using multiple label format, all base points of the formats are offset.
[Remarks]
1. When the print offset is already specified in the advanced mode of the printer, and base point offset is specified with the <A3>
command, the value specified by the <A3> command become valid.
2. The offset value specified by the <A3> command is registered in the advanced mode of the printer. Thus, the offset value
specified by the <A3> command is maintained even the printer power is off.
[Range]
[S84-ex]
Head density
"Horizontal offset (in dot)"
"Vertical offset (in dot)"
8dots/mm (203 dpi)
1 - 832
1 - 1424
12dots/mm (305 dpi)
1 - 1248
1 - 2136
24dots/mm (609 dpi)
1 - 2496
1 - 4272
[S86-ex]
Head density
"Horizontal offset (in dot)"
"Vertical offset (in dot)"
8dots/mm (203 dpi)
1 - 1340
1 - 1424
12dots/mm (305 dpi)
1 - 2010
1 - 2136
Base Offset Setting