SATO s86ex - RFID Command; ESC+IP0 EPC Code Write

289
RFID Command 16
16.1 RFID Command
82.1 ESC+IP0 EPC code write
ESC+IP0
Hexadecimal
code
ESC
IP0
Parameter
<1B>
16
<49>
16
<50>
16
<30>
16
Please refer the below.
Initial value
Nil
Valid range and
term of
command
When the power switch is OFF
The set parameter is not maintained.
Valid range within item
The parameter preset will be invalid.
Valid range between item
The parameter preset will be invalid.
[Function]
This command writes the EPC code and other data to the EPC corresponding RFID tag.
[Format]
[Standard format]
<IP0>e:h(,pcw:xxx)(,epc:xxxx...xxxx)(,usr:xxxx...xxxx)|(,usa:dddd,aaaaa...aaaa)(,lck:bbbbb);
[Conventional format]
<IP0>e:a,c:d,s:d,d:ddddddddddddd(,o:xxx)(,m:bbbbb)(,k:xxxxxxxx)(,a:xxxxxxxx)(,p:xxxxxxxx);
[When SSCC96 code conversion is used]
<IP0>e:c,f:d,c:d,t:d,d:ddddddddddddddddd,n:dddddddddddd(,o:xxx)(,m:bbbbb)(,k:xxxxxxxx)(,a:xxxxxxxx)(,p:xxxxxxxx);
[When SGTIN96 code conversion is used]
<IP0>e:z(,d:xxxxxxxxxxxxxxxxxxxxxxxx)(,u:xxxxxxxxxxxxxxxx)(,k:xxxxxxxx)(,a:xxxxxxxx)
(,p:xxxxxxxx)(,o:xxx)(,m:bbbbb)(,k:xxxxxxxx)(,a:xxxxxxxx)(,p:xxxxxxxx)
;[When free mapping is used]
Note: The above sample specifies typical parameters only. Please refer the below for more details.
●Parameter
EPC encoding type parameter
e:
EPC encoding Type
Specify the parameter right
after <IP0>.
The parameter cannot be
omitted.
h
[Standard format]
Use a 3-character parameter identifier after declaration.
It is possible to write to extended memory areas by each IC chip
manufacturer other than the normal Gen2 tag.
a
[Previous format] SSCC96 code conversion
Use the "one-character parameter identifier".
When the Company prefix/Serial reference/Filter value is received,
and then converted to an SSCC96 compliant code, and written to
the tag.
c
[Previous format] SGTIN96 code conversion
Use the "one-character parameter identifier".
When the Company prefix/Serial reference/Filter value is received,
and then converted to a GTIN96 compliant code, and written to the
tag.
z
[Previous format] Free mapping
Use the "one-character parameter identifier".
When data is written as is without performing code conversion.
EPC code write