SATO s86ex - ESC+PC Registration of Printer Operation

224
12.10 System
ESC+PC Registration of Printer
12.10
Operation
ESC+PC
Hexadecimal
code
ESC
PC
Parameter
<1B>
16
<50>
16
<43>
16
1) [a, b, c, d, … y, z] 2) ｢aa, b｣
Initial value
Refer to the table below.
Valid range and
term of
command
When the power switch is OFF
The set parameter is maintained.
Valid range within item
The set parameter is in effect until a new specification is made.
Valid range between item
The set parameter is in effect until a new specification is made.
[Function]
Registering the operation of the printer
[Format 1] When setting all the items:
<PC>a,b,c,d,e,f,g,h,i1,i2,j,k,l,m,n,o,pppp,qqqq,rrrr,ssss,t,u,v,w,x,y,z
●Parameter
a[Setting item No.] = F Setting for all the items
b[Setting content] = For the contents of parameter, refer to the table below.
[Format 2] When setting specified item:
<PC>aa,b
●Parameter
aa[Setting item No.] = Valid range : 1 to 26
b[Setting content] = For the contents of parameter, refer to the table below.
[Coding Example 1] Setting all the items:
<A>
<PC>F,,,4,,,,,A,4,,1,3,,1,1,3200,832,,,,,,,,,0
<Z>
[Coding Example 2] Setting specified items:
<A>
<PC>26,1
<Z>
[Notes]
1. Go to the User Mode, Advanced Mode or Service Mode of the printer for setting.
2. Operation settings specified with this command are still in effect after turning off the printer.
3. To set all the items, entire or part of parameter entry is omissible by using comma. In this case, comma is not omissible.
When omitting the settings, the default value will be set.
4. Avoid specifying this command while printing or while print data exist. If so, there is no guarantee of proper operation.
5. When there is illegal parameter, the command error occurs and the setting is not saved.
Registration of Printer
Operation