SATO s86ex - ESC+CS Print Speed; System Command

212
System command 12
12.1 System
ESC+CS Print Speed
12.1
ESC+CS
Hexadecimal
code
ESC
CS
Parameter
<1B>
16
<43>
16
<53>
16
aa
Initial value
Refer to the table below.
Valid range and
term of
command
When the power switch is OFF
The set parameter is maintained.
Valid range within item
The set parameter is in effect until a new specification is made.
Valid range between item
The set parameter is in effect until a new specification is made.
[Function]
Specifying the speed of printing.
[Format]
<CS>aa
●Parameter
aa[Print speed] = Refer to the table below
[Coding Example 1] When specifying 6.0 inch/s
<A>
<CS>6
<Z>
[Note]
The print speed value that is set directly by the command or LCD input is maintained.
[Remarks]
1. If the value other than setting range is specified, command error will occur and print speed will not be changed.
2. The initial value is settable by default setting operation of the printer.
[Parameter Initial Value and Specified Range]
Model
Head
density
Initial value
[aa]
Parameter
valid range
The print speed corresponding to the parameter
S84-ex
8dots/mm
(203dpi)
6
4 ~ 16
2 : 2 inch/s (50.8mm/s)
3 : 3 inch/s (76.2mm/s)
4 : 4 inch/s (101.6mm/s)
5 : 5 inch/s (127.0mm/s)
6 : 6 inch/s (152.4mm/s)
7 : 7 inch/s (177.8mm/s)
8 : 8 inch/s (203.2mm/s)
9 : 9 inch/s (228.6mm/s)
10 : 10 inch/s (254.0mm/s)
11 : 11 inch/s (279.4mm/s)
12 : 12 inch/s (304.8mm/s)
13 : 13 inch/s (330.2mm/s)
14 : 14 inch/s (355.6mm/s)
15 : 15 inch/s (381.0mm/s)
16 : 16 inch/s (406.4mm/s)
12dots/mm
(305dpi)
6
4 ~ 14
24dots/mm
(609dpi)
3
2 ~ 6
S86-ex
8dots/mm
(203dpi)
6
4 ~ 14
12dots/mm
(305dpi)
6
4 ~ 12
Print Speed