SATO s86ex - ESC+BG CODE128 (128 A, 128 B, 128 C) Barcode

108
66.1 Barcode
66.1 ESC+BG CODE128 (128A, 128B,
128C) Barcode
ESC+BG
Hexadecimal
code
ESC
BG
Parameter
<1B>16
<42>16<47>16
aabbbn~n
Initial value
Nil
Valid range and
term of
command
When the power switch is OFF
The set parameter is not maintained.
Valid range within item
The parameter preset will be invalid.
Valid range between item
The parameter preset will be invalid.
[Function]
Specifying CODE128 barcode.
[Format]
<BG>aabbbn~n
●Parameter
a[Narrow bar width] = Valid range : 01 to 36 dots
b[Height of barcode] = Valid range : 001 to 999 dots
n[Print data] = Barcode data (Refer to the CODE128 - Code Table)
[Coding Example] Narrow bar width : 02 Height of barcode : 120 Print data : ABCD123456 (START CODE A)
<A>
<V>100<H>200<BG>02120>GABCD123456
<Q>2
<Z>
[Notes]
1. Specify [START CODE] at the head of print data.
(1) START CODE A = [>G]
(2) START CODE B = [>H]
(3) START CODE C = [>I]
2. C/D is an auto-generation.
3. (1) When using “START CODE C”, specify print data in even-numbered digit.
(2) When “START CODE C” is set to print data in odd - number digits, specify “START CODE A” or “B” to change the first one
character of print data. And then specify the rest of data with “Code Set Character C” to change it to even-numbered
digit.
e.g.1) 15 digits [123456789012345] <B>1<C>23456789012345.
e.g.2) 9 digits / Alphanumeric 6 digits [123456789ABC123] <C>12345678<B>9ABC123.
(3) If using “START CODE C” to specify odd-numbered digit, “0” will be added to the tail of print data before printing.
(4) Note that when the compatible mode is on and specify odd-numbered digit with START CODE C, "0" will be added to the
tail of the print data and printed.
(5) When start character is omitted, data will be printed with “START CODE B”.
CODE128 (128A, 128B, 128C)
Barcode