SATO s86ex - Explanation of Input;Output Signal

438
8.3 Explanation of input/output signal
1) Input signal
[Supplemental explanation]
1. Please keep the print start signal (PRIN) to "Low" until print completion signal (PREND) is output.* (Refer to the below
[Maintaining the print start signal (PRIN) keep]) Also, output reprint signal (PRIN2) for more than 10 msec. When signal is
output for shorter than 10 msec, and reprint signal is not acknowledged, the printer will not reprint.
Item
Input waveform
Print
1
2
3
4
20msec
1st label complete
(PREND)
Print end
Print start
(PRIN)
Reprint
(PRIN2)
Print
1st label complete
Print start
(PRIN)
Reprint
(PRIN2)
1
2
3
4
(PREND)
Print end
Reprint (with print start signal)
More than 10mses
Print start
20msec