SATO s86ex - ESC+FC Print of Circles

25
15.1 Modification
15.1 ESC+FC Print of Circles
ESC+FC
Hexadecimal
code
ESC
FC
Parameter
<1B>
16
<46>
16
<43>
16
,aaa,bbb(,c,d)
Initial value
Nil
Valid range and
term of
command
When the power switch is OFF
The set parameter is not maintained.
Valid range within item
The parameter preset will be invalid.
Valid range between item
The parameter preset will be invalid.
[Function]
Specifying the print of circles.
[Format]
<FC>,aaa,bbb(,c,d)
●Parameter
a[Radius] = Valid range: 5 to 999 dots
b[Line width] = Valid range: 1 to 999 dots
c[Sectional number] = Valid range: 0 to 8 If digits are omitted, the default is 0 (zero).
See the details listed below.
d[Pattern] = Valid range: 0 to 3 If digits are omitted, the default is 0 (zero).
0: Solid line (black)
1: Gray 1
2: Gray 2
3: Gray 3
●Sectional number
[Coding Example] Solid line circle of 100 dots in radius, 8 dots in line width
<A>
<V>200<H>200
<FC>,100,8,0,0
<Q>1
<Z>
[Notes]
1. When a section number value outside of the range is specified, it will be processed as “0”. In this case, this will not be a
command error.
2. When the pattern designation value outside of the range is specified, it will be processed as “0”. In this case, this will not be a
command error.
3. When the print start position is outside of the printable area, printing will not be performed due to command error.
4. This command sets the base reference point to the center of a circle.
5. This command can be registered to the format.
6. In case of frame line, the line will be widened for inside.
[Valid range]
Model
Valid range (dots)
Radius
Line width
S84-ex series
5 to 999
1 to 999
S86-ex series
5 to 999
1 to 999
Print of Circles
Section 0
Section 1
Section 2
Section 3
Section 4
Section 5
Section 6
Section 7
Section 8
<V>200
<H>200
0,0
100 in radius