SATO s86ex - External Signal Interface; Basic Specifications

435
8 External signal interface
8.1 Basic Specifications
External interfaces are designed to be able to connect with the printer and the other peripherals.
The external interface operates only in the pulse input mode (a mode that operate according to external signals).
However, error signals are outputted with the all mode.
Setting related to the external signals can be done on the extended setting mode at the printer.
Connector
(1)25 pins external signal interface (D-SUB 25 pins, female terminal)
1
13
14
25
(2) 14 pins external signal interface (amphenol 14 pins, female terminal)
* When using 14 pins external signal interface, please use the attached
conversion cable.
1
7
8
14
Input/Output circuit diagram
(1)25 pins external signal interface (D-SUB 25 pins, female terminal)
a) When the output from the user is NPN transistor output
[Power is supplied from the user]
Photo coupler
2.4kΩ
PrinterUser
Pow
IN
ＯＵＴ
Photo coupler
Transister
（NPN）
+5V～+24V
IN_COM
EXT_I
EXT_O
OUT_COM
Photo Mos FET
[Power is supplied from the printer]
Photo coupler
PrinterUser
Pow
Photo coupler
Transister
（NPN）
IN_COM
EXT_I
EXT_O
OUT_COM
+5V
GND
4.7kΩ
IN
ＯＵＴ
Photo Mos FET