314
Part 2 Interface Specification
1 Overview
1.1 Overview
There are built-in interfaces for data communication with the host system, and an interface that connect external interface for
communication of the printer and peripherals.
The printer has the following built-in interfaces.
1) RS-232C interface (DP9pin (female terminal))
2) LAN interface (10BASE-T/100BASE-TX auto-detecting, RJ45 connector)
3) USB interface (USB2.0 High speed, type A connector/type B connector)
4) IEEE1284 interface (communication mode: ECP mode/compatible, Amphenol 36 pin)
5) External signal interface (D-SUB25 pin)
The following interfaces are optional.
1) Wireless LAN unit (802.11b/g/n)
2) Bluetooth interface (Ver.2.0+EDR Class 2 )
1.2 Function setting
You need to configure each interface in the interface mode of the printer before using it.
1) Procedure to go to the interface mode
Here is the procedure to go to the interface mode to configure each interface.
*When you changed the configuration, be sure to turn the printer’s power off and turn it on again.
(1) Power on the printer, press the LINE key once while the printer is ONLINE.
Printer goes OFFLINE.
(2) Press the ENTER key once. The printer goes to the MODE MENU.
(3) Press the right arrow key twice to move the cursor to .
(4) Press the ENTER key once. The printer goes to the interface mode.
To Next Page
Loading...
