SATO s86ex - ESC+FT Print of Triangles

26
16.1 Modification
16.1 ESC+FT Print of Triangles
ESC+FT
Hexadecimal
code
ESC
FT
Parameter
<1B>
16
<46>
16
<54>
16
,aaaa,bbbb(,cccc,d)
Initial value
Nil
Valid range and
term of
command
When the power switch is OFF
The set parameter is not maintained.
Valid range within item
The parameter preset will be invalid.
Valid range between item
The parameter preset will be invalid.
[Function]
Specifying the print of triangles.
[Format]
<FT>,aaaa,bbbb(,cccc,d)
●Parameter
a[Side length] = Valid range: 10 to 2000 dots
b[Line width] = Valid range: 1 to 1000 dots
c[Base length] = Valid range: 10 to 2000 dots
The base length can be omitted and its value will be equal to the side length.
d[Pattern] = Valid range: 0 to 3 If digits are omitted, the default is 0 (zero).
0: Solid line (black)
1: Gray 1
2: Gray 2
3: Gray 3
[Coding Example] ide length: 100 dots, Line width: 8 dots, Base length: 100 dots
<A>
<V>100<H>200
<FT>,100,8,100,0
<Q>1
<Z>
[Notes]
1. When the pattern value outside of the range is specified, it will be processed as “0”. In this case, this will not be a command
error.
2. When the print start position is outside of the printable area, printing will not be performed due to command error.
3. When the side length is not equal to the base length, printing will not be performed due to command error.
4. This command sets the base reference point to the apex of a triangle.
5. This command can be registered to the format.
6. When the line is widened, the line will be widened for inside.
7. When the length of the base is an odd number, it will be even number automatically by adding 1 to the base length.
[Valid range]
Model
Valid range (dots)
Side length
Line width
Base length
S84-ex series
10 to 2000
1 to 1000
10 to 2000
S86-ex series
10 to 2000
1 to 1000
10 to 2000
Print of Triangles
<V>100
<H>200
0,0
a
a
b
a : Side length
b : Base length