SATO s86ex - ESC+GI Registration of Graphic

243
13.8 Memory Card
ESC+GI Registration of Graphic
13.8
ESC+GI
Hexadecimal
code
ESC
GI
Parameter
<1B>
16
<47>
16
<49>
16
abbbcccdddn~n
Initial value
Nil
Valid range and
term of
command
When the power switch is OFF
The registered data becomes valid.
Valid range within item
The parameter preset will be invalid.
Valid range between item
The parameter preset will be invalid.
[Function]
Specifying the registration of graphic pattern data.
[Format]
<GI>abbbcccdddn~n
●Parameter
a[Selection of data transfer in HEX or BIN] = H : Hex data
B : Binary data
Hex data(specify graphic data as 2 characters of ASCII 0-F is equal to 8 dots )
Binary data(specify graphic data as 1 byte of binary data is equal to 8 dots )
b[Specification of crosswise graphic area per byte] = Refer to the table below
c[Specification of lengthwise graphic area per byte] = Refer to the table below
d[Registration No.] (Identification No. when invoking) = 1 to 999
n[Data] = Graphic data
[Coding Example 1] [H: HEX data] is specified as [Selection of data transfer in HEX or BIN]
<A>
<CC>1
<GI>H001001999<46463831383138313831383138314646>
16
<Z>
[Coding Example 2] [B: Binary data] are specified as [Selection of data transfer in HEX or BIN]
[□] is registered to the 999th of the slot 1 by the below.
<A>
<CC>1
<GI>B001001999 <FF818181818181FF>
16
<Z>
[Notes]
1. Specify registered data only.
2. To change the registered content, clear it with Clear <*> to re-register.
3. Graphic Call <GR> is for printing out the data registered with Registration of Graphic <GI>.
4. When data are not registered properly, print error may occur. For details of data format, refer to Print of Graphic <G>.
5. Attempts to re-register with registered No., an error will occur, and the targeted content will be printed.
6. Specify Card Slot for Use <CC> prior to this command when using.
7. Make sure to specify the slot number used for card slot command <CC> before the graphic registration command <GI>.
8. The error occurs when unused or the slot which the printer is allocated is specified (Refer to Card Slot for Use <CC>).
[Important]
Do not turn the printer power off when accessing to the memory. When the printer power is off while memory accessing,
the data in the accessed media may be corrupted.
Registration of Graphic