SATO s86ex - ESC+RM Mirror Image

36
25.1 Modification
25.1 ESC+RM Mirror Image
ESC+RM
Hexadecimal
code
ESC
RM
Parameter
<1B>
16
<52>
16
<4D>
16
aaaa,bbbbb
Initial value
Nil
Valid range and
term of
command
When the power switch is OFF
The set parameter is not maintained.
Valid range within item
The parameter preset will be invalid.
Valid range between item
The parameter preset will be invalid.
[Function]
Allowing mirror image printing of data.
[Format]
<RM>aaaa,bbbbb
●Parameter
A[Horizontal length of the mirror image area] = Refer to the table below.
B[Vertical length of the mirror image area] = Refer to the table below.
[Coding Example 1] When specifying the mirror image area:
<A>
<H>100<V>200<XM>12345
<H>100<V>200<RM>0200,0080
<Q>1
<Z>
[Coding Example 2] When not specifying the mirror image area:
<A>
<H>100<V>200<XS>12345
<RM>
<Q>1
<Z>
[Notes]
1. When the parameter “aaaa” and “bbbbb” are not specified, all print data specified prior to this command will be mirrored.
2. Any data outside the printable area will not be mirrored.
3. If specifying this command for the item that does not contain print data, the command error will occur.
4. This command cannot be used together with other commands that reedit the print data. Refer to the invalid command for
the list below. When invalid commands are specified, printing may not be correct.
5. This command cannot be used together with some of the control commands. Refer to the invalid command for the list below.
When invalid commands are specified, printing may not be correct.
6. This command cannot be used together with some of the modification commands. Refer to the invalid command for the
list below.
When invalid commands are specified, printing may not be correct.
7. The print image before the mirror printing command will be mirror printed. The print data after this command is not
mirror printed.
Also, note that when specifying the mirror printing command more than once, the image will be rotated for the specified
number of times and printed.
8. When a barcode is mirror printed, the reading of the mirrored barcode and head check area are not guaranteed.
9. When mirror printing is implemented, all mirrored image is targeted for the head check.
[Valid range for the mirror rotation start position]
[S84-ex]
Head density
Valid Range (dots)
Horizontal position of reference
point for mirror image
Vertical position of reference
point for mirror image
8 dots/mm (203 dpi)
1 to 832
1 to 20000
12 dots/mm (305 dpi)
1 to 1248
1 to 18000
24 dots/mm (609 dpi)
1 to 2496
1 to 9600
[S86-ex]
Head density
Valid Range (dots)
Horizontal position of reference
point for mirror image
Vertical position of reference
point for mirror image
8 dots/mm (203 dpi)
1 to 1340
1 to 9992
12 dots/mm (305 dpi)
1 to 2010
1 to 14988
Mirror Image