SATO s86ex - ESC+WD Partial Copying

32
22.1 Modification
22.1 ESC+WD Partial Copying
ESC+WD
Hexadecimal
code
ESC
WD
Parameter
<1B>
16
<57>
16
<44>
16
VaaaaaHbbbbYcccccXdddd
Initial value
Nil
Valid range and
term of
command
When the power switch is OFF
The set parameter is not maintained.
Valid range within item
The parameter preset will be invalid.
Valid range between item
The parameter preset will be invalid.
[Function]
Copying an image from one location to another on the same label.
[Format]
<WD>VaaaaaHbbbbYcccccXdddd
●Parameter
a[Vertical position of the top left corner of the area] = See the table below
b[Horizontal position of the top left corner of the area] = See the table below
c[Vertical length of the image area to be copied] = See the table below
d[Horizontal length of the image area to be copied] = See the table below
[Coding Example] Vertical position of the top left corner of the area: 50 Horizontal position of the top left corner of the area: 50
Vertical length of the image area to be copied: 200 Horizontal length of the image area to be copied: 400
<A>
<V>50<H>50<P>2<L>0202<XU>ABCD
<V>300<H>100<WD>V50H50Y200X400
<Q>2
<Z>
[Notes]
1. To locate the destination of the copy, specify Vertical Print Position <V> and Horizontal Print Position <H> prior
to this command.
2. The position of the new target area must not be inside the original image.
3. If the reference area of the target image exceeds the printable area, printing will not be performed due to command
error.
[Valid Range]
[S84-ex]
Head density
Valid range (dots)
The horizontal position of
the top left corner of the
area
Horizontal length of the
image area to be copied
The vertical position of the
top left corner of the area
Vertical length of the image
area to be copied
8 dots/mm (203 dpi)
1 to 832
1 to 20000
12 dots/mm (305 dpi)
1 to 1248
1 to 18000
24 dots/mm (609 dpi)
1 to 2496
1 to 9600
ＡＢＣＤ
ＡＢＣＤ
aaaaa
bbbb
ccccc
dddd
Media direction
Dotted line part indicates the area to be copied.
“ABCD” will be printed .
Partial Copying