SATO s86ex - ESC+Q Print Quantity

12
3.1 Control
3.1 ESC+Q Print Quantity
ESC+Q
Hexadecimal
code
ESC
Q
Parameter
<1B>
16
<51>
16
aaaaaa
Initial value
aaaaaa=1
Valid range and
term of
command
When the power switch is OFF
The set parameter is not maintained.
Valid range within item
The parameter preset will be invalid.
Valid range between item
The parameter preset will be invalid.
[Function]
Specifying the number of labels to print.
[Format]
<Q>aaaaaa
●Parameter
a[Number of labels to print] = Valid range: 1 to 999999
[Coding Example] Number of labels: 2
<A>
<V>100<H>200<P>2<L>0202<XM>ABCD
<Q>2
<Z>
[Notes]
1. Print contents specified by Start of Data Transmission <A> and End of Data Transmission <Z> are regarded as 1 label, and
the number of reprints can be specified.
2. Use this command prior to End of Data Transmission <Z>.
[Remark]
The reprint will be performed based on the specified print quantity. If specifying Sequential Numbering <F>, the value of
sequential number that was set up for that field portion will print.
Print Quantity