SATO s86ex - ESC+2 D30 QR Code(Model 2)

134
77.1 2D code
77.1 ESC+2D30 QR Code(Model 2)
ESC+2D30
Hexadecimal
code
ESC
2D30
Parameter
<1B>
16
<32>
16
<44>
16
<33>
16
<30>
16
,a,bb,c,d(,ee,ff,gg)
Initial value
Nil
Valid range and
term of
command
When the power switch is OFF
The set parameter is not maintained.
Valid range within item
The parameter preset will be invalid.
Valid range between item
The parameter preset will be invalid.
[Function]
Specify QR code (model 2)
[Format](setting part)
<2D30>,a,bb,c,d(,ee,ff,gg)
●Parameter
a[Error correction level(error correction)] = L : 7%
M : 15%
Q : 25%
H : 30%
b[Size of a side] = Valid range : 01~99(dots)
* Recommend to specify more than 2 dots for 12dots/mm, and 4 dots for 24 dots/mm for scanner readability.
c[Data setting mode] = 0 : Manual setting
1 : Auto setting
* Note that the print data specification varies according to this setting.
d[Combine mode] = 0 : Normal mode
1 : Combine mode
* Please specify the below parameter when combined mode 1 is specified.
Omit the below parameter with the normal mode.
e[Division number of combine mode] = Valid range : 01 ～ 16
* Specify how many divided QR code are to be combined with the combine mode.
f[Sequential number of divided combine mode] = Valid range : 01 ～ 16
* Specify what number of divided QR code.
g[Parity data of combine mode] = Valid range : 00 ～ FF
*Specify the data that is a calculation (exclusive OR) of all divided QR code print data in HEX.
[Format](data part)
Manual setting (Data setting mode)
<DS>k,n～n * This is used when the input mode is numeric mode, alphanumeric mode and Kanji code.
<DN>mmmm,n～n * This is used when specified by binary.
Auto setting (Data setting mode)
<DN>mmmm,n～n * The input mode is automatically switched by the input data.
[Format](version specification)
<QV>pp * This is used when specifying the version.
●Parameter
k[Input mode] = 1 : Numeric mode
2 : Alphanumeric mode
3 : Kanji mode(Shift JIS Kanji code)
* specify this setting only when the manual setting is specified in the data setting mode.
* Note that there is a binary specification other than above, however, the data specification command is different.
m [Number of data] = Valid range: 1~2953
* Specify this setting when auto setting in the data setting mode or binary specification in manual setting is specified.
n[Print data] = data
pp [Version] = 00～40(MODEL2)
* Use this setting when fix the QR symbol size. When this is not specified, it will be auto.
It will be auto when 00 is specified. The parameter error will not occur in the range of 00~40.
* Refer to the "QR code version specification command" for more details.
QR Code (Model 2)