SATO s86ex - Operation Sequence

404
Operation Sequence 6.8.3
[Supplemental explanation]
1. Time correction is only when printer is turned on. Time correction will fail when NTP server doesn't respond (timeout period is
4 sec).
2. The following display will be shown and there will be buzzer sound when time correction has failed and "Setting of
communication error notice" is "ENABLE".
3. The maximum waiting time from starting time acquisition from NTP server to displaying time correction failure screen is approx.
37 sec. The condition to become the maximum waiting time is enabling DHCP setting of IP address setting of the printer and all
become time-out. Time-out period for each setting is as follows.
-Time-out period of DHCP is approx. 33 seconds.
-Time-out period of NTP is approx. 4 seconds.
Communication error display
INITIALYZING...
S8xxx
VER:61.00.00.00
ONLINE
QTY：000000
Power on
”SNTP function” is enabled
Calendar IC is mounted and LAN interface
NTP server time acquire request
Calendar IC time offset
NO
YES
NTP server
NTP server time acquire response
When there is a response
“Communication error notice” is enabled
NO
YES
FAILED TO
ADJUST CLOCK
YY/MM/DD HH:MM
Press the ENTER key
When there is no response
調整モード
FAILED TOFAILED
TOADJUST CLOCK
YY/MM/DD hh:mm