SATO s86ex - Esc+K8 16×16 Dots Vertical Writing Kanji with One-Byte Characters

71
46.1 Font
46.1 ESC+k8 16×16 dots Vertical
Writing Kanji with One-byte Characters
ESC+k8
Hexadecimal
code
ESC
k8
Parameter
<1B>
16
<6B>
16
<38>
16
an～n
Initial value
Nil
Valid range and
term of
command
When the power switch is OFF
The set parameter is not maintained.
Valid range within item
The parameter preset will be invalid.
Valid range between item
The parameter preset will be invalid.
[Function]
Printing W16 x H16 dots vertical text flow Kanji font with W8 x H16 dots one-byte characters.
[Format]
<k8>an～n
●Parameter
a[Kanji specification mode] = H : Hexadecimal character
B : Binary code
I : Smoothing function by Hexadecimal character
C : Smoothing function by Binary code
J : Highlight function by Hexadecimal character
D : Highlight function by Binary code
K : Smoothing and highlight functions by Hexadecimal character
E : Smoothing and highlight functions by Binary code
n[Data] = Specify according to the selected Kanji code range
* Printing may not be correct when the number of data is increased/decreased.
* Code that can be specified as a half - width character is 20h-7Fh.
[Coding Example] Specified character in HEX, horizontal enlargement: 2 times,
vertical enlargement: 3 times (when KSX1001 is selected)
<A>
<V>100<H>200<P>2<L>0203
<k8>HB0A1B0A2B0A3B0A4B0A5303132
<Q>2
<Z>
[Notes]
1. Hexadecimal character = 4 bytes ASCII / 1 character
2. Binary code = 2 bytes ASCII / 1 character
3. Smoothing function enlargement scale = Horizontal/Vertical valid range: 3 to 12 times
4. Highlight function enlargement scale = Horizontal/Vertical valid range: 1 to 5 times
[Remarks]
1. In highlight function, the character width will increase based on the enlargement specification.
2. In highlight function, smearing problem may occur depending on the characters.
3. Printable fonts vary according to the font type. Make sure to check if it is printable or not before using.
4. For one-byte characters, printing will be performed in W8 x H16 dots.
5. For two-byte characters, printing will be performed in W16 x H16 dots.
[Valid Commands]
Print position
<V>
<H>
Modification
<P>
<L>
<%>
<&>
</>
<O>
<WD>
16×16 dots Vertical Writing Kanji
with One-byte Characters