SATO s86ex - ESC+2 D70 Aztec Code

206
10.9 2D code
ESC+2D70 Aztec code
10.9
ESC+2D70
Hexadecimal
code
ESC
2D70
Parameter
<1B>16
<32>16<44>16<37>16<30>16
,a,bb,cc,ss,e,f～f
Initial value
Nil
Valid range and
term of
command.
When the power switch is turned off
The set parameter is not maintained.
Valid range within item
The set parameter becomes invalid.
Valid range between items
The set parameter becomes invalid.
[Function]
Specify the Aztec code.
[Format] Setting part
<2D70>,a,bb,cc,dd,e,f～f
●Parameters
a [Symbol type] = 0 : Full range symbol
1 : Compact symbol
b [Error correction percentage] = 0 : default error correction level
01 - 99 : error correction percentage
c [Symbol size] 0 ： Auto minimization
1 -4 : 1 - 4 layer (compact symbol) * Refer to the below symbol size table
4 -32 : 4 - 32 layer (full range symbol) * Refer to the below symbol size table
d [Number of symbols at structured append mode] = 0 ： Encode without appending
1 : Auto setting
2 - 26: Structured append block number
e [Message ID] = Y: specify the message ID
N ： Do not add message ID
f [Message ID of structured append symbol]
= Printable ASCII characters (excluding space), up to 24 bytes
[Format] Data part
<DS>n - n // in case of ASCII data
<DN>mmmm, n - n // in case of binary data
●Parameters
m [Number of data] = 0001 to 1914
- this parameter is set when print data is binary format
n [Print data] = data
- specify [1BH,1BH] when selecting [1BH]
- specify [1BH,30H] when selecting [FNC1]
- make sure to write [1BH,*] when selecting [ECl] ('*' specifies a value between 31H to 36H)
[Coding example]
Symbol type: compact, ECC percentage: default, symbol size: 2 layers, number of symbols at structured append: encode without
appending, message id: None, message ID of structured append symbol: none, barcode data: THIS IS TEST
<A> ● Generated Label
<V>0100<H>0100<L>0404
<2D70>,1,0,2,0,N,<DS>THIS IS TEST
<Q>1
<Z>
(Note)
1. The symbol might not be printed when a parameter other than described above is specified.
2. The symbol may not be read by a scanner when the size of Aztec code is small. In the case, enlarge the size of the symbol for
reading by using <ESC>L command that vertical and horizontal enlarge ratio is the same.
3. The minimum size of the symbol is 15 x 15 module, and the maximum is 151 x 151 module. Refer to the below table for
available Aztec code format and the maximum size.
Aztec code