SATO s86ex - Return Status

317
2.2 Return Status
Purpose of return status is to control the printer status from the host, and the printer returns the status after receiving the status
request command.
There are 4 kinds of return status; Status 2, Status 3, Status 4, and Status 5. The return status is as follows.
The printer returns the status after receiving the status request command.
Communication
Protocol
Command
Command name
Data
Port
Sub
Port
Note
READY/BUSY
－
－
○
×
*1
XON/XOFF
－
－
○
×
*1
Status 2
ENQ
Status request command
○
○
Excluding HEX dump mode
CAN
Cancel request command
○
×
Status 3
ENQ
Status request command
○
○
Excluding HEX dump mode
CAN
Cancel request command
○
×
Status 4
ENQ
Status request command
○
○
Excluding HEX dump mode
CAN
Cancel request command
○
×
DLE
Print pause request command
○
×
Disabled in Bluetooth
DC1
Print resume request command
○
×
Disabled in Bluetooth
Status 5
SOH + ENQ
Status request command
○
○
Excluding HEX dump mode
SOH + CAN
Cancel request command
○
×
SOH + DLE
Print pause request command
○
×
SOH + DC1
Print resume request command
○
×
Status 3
Status 4
Status 5
SOH + MG
Print configuration request
○
○
SOH + SB
System version information request
○
○
SOH + EB
Free memory space information request
○
○
SOH + FO
Form overlay information request
○
○
SOH + CR
Status 5 setting information request
○
×
SOH + LW
Status 5 history data information request
○
×
SOH + LA
LAN information request
○
×
SOH + WI
Wireless LAN field intensity information request
○
○
SOH + H5
Wireless LAN interface information request
○
×
SOH + wa
Association Threshold information request
○
×
SOH + wr
Roaming Threshold information request
○
×
SOH + WS
Work shifts information request
○
×
[○：supported, ×：not supported]
*1 The Sub Port of READY/BUSY and XON/XOFF is configurable, but the commands that can be used for the Sub Port are
not supported.