SATO s86ex - Return Status of Status 3

320
Return status of Status 3 2.2.2
The printer returns the printer’s status and reply as the status by receiving 3 types of request commands and print command
with this communication protocol.
Details of request commands and return status are described below.
1) Status request command
The printer returns the job ID number of receive data that is currently printing, the printer status and the number of the
remaining labels to print to the host by receiving this command. Return all "0" (HEX 30H) as the print quantity after
printing is finished or there is no more receive data. If the command Job ID Number <ID> is not specified, the ID number
returns space (HEX 20H).
Avoid sending ENQ while sending the print data (STX <A> - <Z> ETX). This may cause return status error or print error.
(1) Command ENQ (HEX 05H)
(2) Return status format (for other than Port 3 (9100) that LEGACY STATUS setting is enabled)
Status
Job ID number will be set by the job ID number specified by job ID number
Specify <ID> in the ESC<A>-ESC<Z>.
When there are multiple receive data, ID number of the current printing
Receive data will be set.
STX
ETX
ID No.
Remaining print No.
000000 - 999999
(11 bytes in total)
Return status format
(for Port 3 (9100) that LEGACY STATUS setting is enabled, and for Port 1 (1024) when using Wireless LAN)
Status
Job ID number will be set by the job ID number specified by job ID number
Specify <ID> in the ESC<A>-ESC<Z>.
When there are multiple receive data, ID number of the current printing
Receive data will be set.
STX
ETX
ID No.
No. of remaining labels
From 000000 to 999999
まで
(Total 15 bytes)
Size
0000000BH
(4 bytes)