SATO s86ex - ESC+* Clear

218
12.6 System
ESC+* Clear
12.6
ESC+*
Hexadecimal
code
ESC
*
Parameter
<1B>
16
<2A>
16
a
Initial value
Nil
Valid range and
term of
command
When the power switch is OFF
The set parameter is not maintained.
Valid range within item
The parameter preset will be invalid.
Valid range between item
The parameter preset will be invalid.
[Function]
Clearing the contents registered in the internal memory.
[Format]
<*>a
●Parameter
a[Item to be cleared] = Not specified : Single item receive buffer, editing buffer (No reprint is allowed)
Multi item receive buffer, editing buffer (Clears JOB while printing)
T : External character registration area
& : Form overlay
X : All clear
(Receive buffer, editing buffer, registration of external character, form overlay)
*Clears JOB while printing
S : Sub port receive data
H : History (Print log, STATUS5)
[Coding Example 1] Clears receive buffer and editing buffer
<A>
<*>
<Z>
[Coding Example 2] All clear
<A>
<*>X
<Z>
[Coding Example 3] Clears external character registration area
<A>
<*>T
<Z>
[Coding Example 4] Clears receive data from sub port
<A>
<*>S
<Z>
[Notes]
1. Delimit Start of Data Transmission <A> and End of Data Transmission <Z> with this command to use.
2. Sending a=X (all clear) of this command will clear all data sent before the execution of this command. And also, registration
of external character and form overlay will be cleared. In this case, the data that were analyzed while printing can not be
cleared.
[Remark]
The specification of this command while printing will not stop the print operation.
Clear