269
[Notes]
1. Use
this command
in betw
een Start
of Da
ta Tran
smission <A>
and
End of
Data
Transmission <Z>
. This
c
ommand
is disabled
when this is specified in the item with print data.
2. Do not specify too long feed distance for backward direction. When too long distance is specified in the backward direction,
printing may be overlapped or the media fell off from the platen roller and the paper end error may be falsely detected.
3. Do not specify the feed length of the backward position for more than 30mm when the print method is thermal transfer.
The command error occurs due to the possibility of ribbon end false detection. Furthermore, do not specify the media feed
command for the backward direction continuously.
4. Do not specify the media feed command for backward direction just after dispensed label in dispense mode.
5. The feeding speed is fixed for 4inches/sec when media feed length is specified.
6. The operation of the printer when the feeding length is omitted for forward direction is the same as the media feed when
FEED key is pressed while the printer is offline.
7. The media feeding by this command is done when the printer is online.
8. Control of feeding is not available by the external signal.
9. The command error occurs when the feeding length is omitted with backward direction.
10. The media feed by <IK>0(feeding length is omitted) cannot be done when the sensor is ignored in the continuous printing
mode.
11. The command error occurs when the feeding length is out of range.
12. Note that the printing may be overlapped according to the feed length of backward direction.
13. The accuracy may vary depending on the printer, used media and environment. Adjust the feeding length when using.
[Valid range (For forward direction)]
[S84-ex]
[S86-ex]
[Valid range (For backward direction)]
[S84-ex]
[S86-ex]
To Next Page
Loading...
