SATO s86ex - Page 304

296
10.SGTIN96 code conversion
This function is used to generate a code according to the SGTIN96 standard when a company prefix, item reference,
filter value, and serial number are applied. It is possible to use with Gen2. This function is explained with the below
values. All numbers below are in decimals.
Company prefix: 003885 (6 digits)
Item reference: 4006606 (7 digits)
Filter value: 0 (Select the filter value from the filter value standard table described earlier.
Serial number: 000000000001 (fixed to 12 digits)
The total digit number of company prefix and item reference needs to be 13 under the standard, and it is not possible to
change. Of these 13 digits, the proportion of the company prefix and the item reference can be selected from the seven
combinations described in the table below.
Partition value
Company prefix digit
Item reference digit
0
12
1
1
11
2
2
10
3
3
9
4
4
8
5
5
7
6
6
6
7
In this example, according to the table above,
Company prefix digit number: 6
Item reference digit number: 7
The partition value is 6, but since this value is generated within the printer, it is not necessary to be specified.
Under this condition, if the format of <IPO> EPC code write is applied, it results in the following:
When the standard format is used
<IP0>e:h,enc:c,com:003885,itm:4006606,flt:0,srl:000000000001;
Description of each parameter
e:h,------------- Specifies the standard format
enc:c,------------ Specifies SGTIN96 code conversion
com:003885,-------------- The company prefix is 6 digits
itm:4006606,------------- The item reference is 7 digits 13 digits when combined with com:
flt:0 ----------- The filter value is All Others
srl:000000000001--- Serial number, fixed at 12 digits 274877906943 or a smaller number.
;---------------- End terminal
When the one-character parameter identifier in the conventional format is used
<IP0>e:c,c:6,t:7,f:0,d:0038854006606,n:000000000001;
Description of each parameter
e:c,------------ Specifies SGTIN96 code conversion
c:6,-------------- The company prefix is 6 digits
t:7,------------- The item reference is 7 digits 13 digits when combined with c:
f:0,-------------- The filter value is All Others
d:0038854006606, –Number in which the company prefix and item reference are joined together It is 13 digits.
N:000000000001--- Serial number, fixed at 12 digits 274877906943 or a smaller number.
;---------------- End terminal
When these commands are executed, the above parameters are converted to SGTIN96 code
301803CB4F48B38000000001 and 24 characters, and are written in a tag.