SATO s86ex - Page 314

306
[Valid command]
Font
<XL>
<XM>
<XS>
<XU>
<XB>
Barcode
<B>
<D>
<BD>
<2D10>
<2D12>
<2D20>
<2D30>
<2D31>
<2D50>
<DN>
<DS>
[Notes]
1. This command support 1D barcode commands: <B>, <D>, and <BD>. Regarding only CODE39 can be specified.
2. When using 2D code and also specifying the ID by using <DN> in the data part, specify the number of characters before
conversion to the number of data. Example: <DN>0004,SATO
3. Alphanumeric characters can be used when using QR code. (Numeric and Kanji mode is not available.) Micro QR code is not
available. ID cannot be specified to the secured part of the Security QR code.
4. In case if tag data could not be read, an error message will be printed and will retry with the next label or discard depending
on the retry/release setting.
5. In case of a command error due to erroneous format of print job that includes this command, the printer will not print label (so
as not to waste label) but will ring the buzzer once short to go to OFFLINE. The label will not be printed until the reason of
command error is removed.
6. In case if the settings are made to ignore the sensor, the command error occurs upon receive of this command.
7. This command cannot be used for the label that tag offset is set to other than default.
8. This command cannot be used with dispense mode behavior 2.
9. The item including this command does not support <C>, and <0> command, external signals, and reprint by key operation.
10. This command can be used together with EPC code write command <IP0>. In this case, the printer read (TU), write (IP0)
and print, regardless the order of command. Therefore, the data written by <IP0> command cannot be read with this
command.
11. It is possible to specify a pair of <TU>1 and <TU>0 in 1 item. Make sure to specify <TU>0 when <TU>1 is specified.
12. This command cannot be specified together with sequential printing or registering formats.
13. You cannot specify multiple labels for print jobs that include this command. Even if you specify 2 or more labels with
<Q> command, it will be interpreted as 1.
14. This command will not be executed while the printer is printing. It will be executed after the print is complete.