SATO s86ex - Page 348

340
6) LAN Specification Information request(IPv6)
The printer returns the LAN IPv6 setting information of the printer to the host by receiving this command.
(1) Command SOH (01H) + lA
(2) Return status/format
[STX] + MAC address + IP address + Prefix + Default router + Address Resolution + [ETX]
STX
MAC
Address
IP
Address
Prefix
Default
Router
Address
Resolution
ETX
(3) Return status list
No.
Item
Description
Number of bytes
1
MAC address (HEX)
Return MAC address that is set
6
2
IP address (HEX)
Return IP address that is set
16
3
Prefix (HEX)
Return prefix that is set
1
4
Default router (HEX)
Return default router address that is set
16
5
Address resolution
0 (00H) : Manual
1 (00H) : DHCP
2 (01H) : Auto
1
7) Wireless LAN field intensity information request
The printer returns the wireless LAN field intensity information to the host by receiving this command.
(1) Command SOH (01H) + WI
(2) Return status format
[STX] + field intensity + [ETX]
STX
Field intensity
ETX
(3) Return status list
No.
Item
Description
Number of bytes
1
Field intensity
X: Wireless LAN kit is not installed/Failed to acquire field intensity
0 (30H) : - Less than Signal Level 1 (not connected)
1 (31H) : Signal Level 1 - Less than Signal Level 2 (weak)
2 (32H) : Signal Level 2 - Less than Signal Level 3 (medium)
3 (33H) : Signal Level 3 - (strong)
1
8) Status 5 setting information request
The printer returns the status 5 setting information to the host by receiving this command.
(1) Command SOH (01H) + CR
(2) Return status format
[STX] + Status 5 setting information + [ETX]
STX
BCC check
,
(2CH fixed)
Item No check
ETX
(3) Return status list
No.
Item
Description
Number of bytes
1
BCC check
0 (30H) : Disabled BCC check
1 (31H) : Enabled BCC check
1
2
, (comma)
2CH (fixed)
1
3
Item No. check
0 (30H) : Disabled item No. check
1 (31H) : Enabled item No. check
1
9) Wireless LAN interface information request
The printer returns the wireless LAN interface setting to the host by receiving this command.
(1) Command SOH (01H) + H5
(2) Return status format
[STX] + wireless LAN interface setting information+[ETX]
STX
Wireless LAN interface setting
information
ETX
(3) Return status list
No.
Item
Description
Number of bytes
1
Wireless LAN
interface
setting information
00H : 2 port connection/cycle response (status 4)
01H : 2 port connection/ENQ response (status 4)
02H : 1 port connection/ENQ response (status 3)
03H : 1 port connection/ENQ response (status 5)
1
10) Association Threshold information request
The printer returns the threshold that starts the association process to the host by receiving this command.
STX (HEX 02H)
ETX (HEX 03H)
(Total 5 bytes)
STX (HEX 02H)
ETX (HEX 03H)
(Total 3 bytes)
STX (HEX 02H)
ETX (HEX 03H)
(Total 3 bytes)
STX (HEX 02H)
ETX (HEX 03H)
(Total: 42 bytes)