SENSTAR OmniTrax - Page 116

Preparation of trenches
Page 116 OmniTrax Product Guide
4. Lay the sensor cable in the trench(es) or slots one cable at a time.
Figure 81: Laying lead-in cable
processor
enclosure
NOT TO SCALE
leave enough cable at the processor location to
form a 2 m service loop (if the ends of the lead-in
cables have been damaged or contaminated during
installation, cut off the damaged cable, minimum
lead-in length = 6 m)
align red bands
at start point of
detecting cable
position and secure the
ferrite beads
cable
reel