Installation overview
Page 26 OmniTrax Product Guide
The following table lists the OmniTrax system components and provides links to relevant sections
in the Product Guide.
Installation overview
Installing an OmniTrax system is a five step process:
1. Install the processor and enclosure.
• power supply
• earth ground
• alarm communication wiring
2. Install the sensor cables.
• mark the cable path
• dig trenches, cut slots
• lay cables
• verify installation
3. Complete the cable burial and restore surfaces.
4. Setup and calibrate the system.
5. Perform verification testing over the length of the sensor cables.
Component Page reference Component Page reference
processor page 171
ferrite beads (SC1) page 121
OmniTrax enclosure page 86 ferrite beads (SC2) page 121
telecom enclosure page 86 cable splice (OC2) page 141
OC2 sensor cable page 19 cable splice (SC1) page 141
SC1 sensor cable page 20 cable splice (SC2) page 141
SC2 sensor cable page 20 power supply (12 VDC) page 163
connectors (OC2) page 121 power supply (48 VDC) page 163
connectors (SC1) page 126 auxiliary device power
supply module
page 165
connectors (SC2) page 126 back-up battery page 167
standalone decoupler page 56 Relay Output card page 185
network decoupler page 56 Universal Input card page 186
long terminator (OC2) page 139 Network Interface card page 183
long terminator (SC1) page 138 Silver Network Manager page 220
long terminator (SC2) page 139 Network Interface Unit page 220
sensor cable lightning
protection
page 179 Silver repeater page 224
ferrite beads (OC2) page 121
To Next Page
Loading...
