Network components
Page 222 OmniTrax Product Guide
OmniTrax sensor
The OmniTrax sensor is a covert, high-security system, that uses a set of buried cables to create a
volumetric detection field around a perimeter. Each processor can monitor two independent
sensor cable sets, each with up to 400 m of detecting cable. OmniTrax provides precise target
location, and each processor supports up to 50 distinct software-defined sensor zones. In addition
to the standard network communication media, the OmniTrax processor can use its sensor cables
to carry the Silver Network data.
XField sensor
The XField sensor system is a terrain following, volumetric perimeter intrusion detection system.
XField creates an electrostatic detection field around parallel transmit and receive wires, which are
mounted on fences or free-standing posts. Each processor monitors two independent 4-wire, or
5-wire, sensor zones up to 150 m in length. The two zones can be stacked to create a single 8, 9,
or 10-wire, sensor zone.
FlexZone sensor
The FlexZone fence protection system uses loose-tube coaxial sensor cables mounted on a fence
to detect vibrations caused by climbing, cutting, lifting, or otherwise disturbing the fence fabric.
Each FlexZone processor can monitor the activity from one or two sensor cables, each up to
300 m (984 ft.) long, and will report the alarm status of up to 60 software defined sensor zones.
FlexZone will locate the source of a disturbance to within ± 3 m (10 ft.). A single pass of sensor
cable can protect a high quality chain-link fence up to 4.3 m (14 ft.) high. There are two models of
the FlexZone processor available. The FlexZone-4 processor supports up to 4 software defined
alarm zones, but does not report target location. The FlexZone-60 processor supports up to 60
distinct alarm zones and accurately locates targets.
FlexPS sensor
The FlexPS fence protection system uses microphonic sensor cable mounted on a fence, to detect
attempts to cut, climb, lift, or otherwise disturb the fence fabric. FlexPS provides two independent
sensor zones, with each zone up to 300 m (984 ft.) in length. A single pass of sensor cable will
protect fences up to 2.5 m (8 ft.) high. Additional passes of sensor cable are recommended for
fences that are higher than 2.5 m. FlexPS includes 4 output relays and 2 auxiliary device inputs
which are available to the host security management system.
Senstar LM100 sensor
The Senstar LM100 intelligent perimeter lighting and sensing solution combines LED lighting with
a vibration detection sensor. The system is comprised of a distributed set of LM100 luminaires,
which include the high-intensity LED lights and the accelerometer-based vibration detecting
sensor, a gateway device that processes the signals from the luminaires, and a luminaire AP
(access point) that provides an RS-485 half-duplex connection between the RF-based luminaires
and the gateway. The Senstar LM100 luminaires are typically mounted on the perimeter fence, but
can also be mounted on walls or other surfaces. They communicate over a proprietary wireless
mesh network transmitting status information and receiving control point commands from the
gateway via the hard-wired connection to the AP. The gateway provides the user interface to the
distributed luminaires as well as the interface between the sensors and a security management
system. The Senstar LM100 gateway supports up to 100 luminaires including the luminaire AP.
To Next Page
Loading...
