Page 2 OmniTrax Product Guide
Senstar Corporation
Website: www.senstar.com
Email address: info@senstar.com
A4DA0102-001, Rev J
December 13, 2019
OmniTrax, XField, FlexZone, µltraWave, FlexPS, Sennet, Perimitrax, Senstar and the Senstar logo are registered trademarks,
and Silver Network, StarNeT 1000 and Sentrax are trademarks of Senstar Corporation. Other Product names and Company
names included in this document are used only for identification purposes and are the property of, and may be trademarks of,
their respective owners. Copyright © 2017, 2007, Senstar Corporation. All rights reserved. Printed in Canada.
The information provided in this guide has been prepared by Senstar Corporation to the best of its ability. Senstar Corporation is
not responsible for any damage or accidents that may occur due to errors or omissions in this guide. Senstar Corporation is not
liable for any damages, or incidental consequences, arising from the use of, or the inability to use, the software and equipment
described in this guide. Senstar Corporation is not responsible for any damage or accidents that may occur due to information
about items of equipment or components manufactured by other companies. Features and specifications are subject to change
without notice.
Equipment certifications and approvals:
Canada:
Industry Canada has authorized this equipment for operation in Canada as a license exempt device under the following
conditions:
The OmniTrax system requires professional installation, which must ensure that the General Field Strength Limits listed in
Tables 2 and 3 of RSS-210 are not exceeded.
This device may not cause radio interference, and this device must accept any interference received.
USA:
FCC identifier: I5T-A4EM0101
Note: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is
operated in a commercial environment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not
cause harmful interference, and (2) this device must accept any interference received, including interference that may cause
undesired operation.
Any changes or modifications to the software or equipment that are not expressly approved by Senstar Corporation void the
manufacturer’s warranty, and could void the user’s authority to operate the equipment.
The OmniTrax system requires professional installation.
Europe:
This device conforms to EN 61000-6-4: 2001 relating to Electromagnetic compatibility for emission standards for industrial
environments.
This device conforms to EN 50130-4: 1995 + amendments A1: 1998 & A2: 2003 relating to Electromagnetic compatibility for
immunity requirements for components of fire, intruder, and social alarm systems.
The use of shielded cables is required for compliance.
Senstar Corporation’s Quality Management System is ISO 9001:2008 registered.
Senstar Corporation’s intellectual property is protected by the following patents:
Canada - 2204485
USA - 7576648
Europe - U.K. 2318689
Patents issued and pending in other Countries.
To Next Page
Loading...
