6-13
4. Press <NEXT> or <PREVIOUS> until <CONFIGURE POINTS> is
displayed and then press <ENTER>.
5. Press <NEXT> or <PREVIOUS> to scroll through your choices until
<ANALOG PSEUDOS> is displayed and then press <ENTER>.
6. Use <NEXT> or <PREVIOUS> to scroll through your points until the
desired point (A27 through A50) is displayed and then press Enter.
7. Press <NEXT> or <PREVIOUS> to scroll through your list of choices until
the desired option is displayed and then press Enter. Your choices are
shown in Table 6-5.
Table 6-5. Analog Pseudo Point Configuration Choices
Function Description
Edit Device Type
(See Note 1)
Changes the Hardware Device Type of the Point
Edit Point Type
(See Notes 2 and 3)
Changes the Software Point Type of the Point.
Your choices are:
• Analog
• Timer
• Counter
Edit Point Label
(See Note 3)
Changes the 40-Character Label of the Point
Clear Point Label
(See Note 3)
Blanks the 40-Character Label of the Point
Edit Mode
(See Note 1)
Changes the Mode of Operation for the Point
Notes:
1. This function not allowed for Analog Pseudo points.
2. For a complete list of your choices for these edit functions, refer
to “Appendix B. Hardware and Pseudo Points.”
3. To complete these functions, refer to their appropriate section
in this publication.
Configuring Digital and Analog Pseudo Points, Continued
Configuring Analog Pseudo
Points (continued)
Pro
rammin
Technical Manuals Online! - http://www.tech-man.com
To Next Page
Loading...
Need help?
General
