Using a" Memory Stick" - Introduction
You can select the image quality mode in still image recording. The default setting is
FINE.
(1) Set the POWER switch to VCR or MEMORY. Make sure that the LOCK switch
is set to the left (unlock) position.
(2) Press MENU to display the menu settings.
(3) Tm-n the SEE/PUSH EXEC dial to select STILL SET in _[_, then press the dial.
(4) Tm-n the SEE/PUSH EXEC dial to select QUALITY, then press the dial.
(5) Turn the SEE/PUSH EXEC dial to select the desired image quality, then press
the dial.
3
4
5
128
To Next Page
