Sony CCD-TRV118 - Frame by Frame Recording - Frame Recording; To Cancel the Frame Recording

Frame by frame recording
- Frame recording
You can make a recording with a stop motion animated effect using frame recording.
To create this effect, alternately move tile subject a little and make a frame recording.
We recommend that you use a tripod, and operate your camcorder using the Remote
Commander after step (5).
(1) In the standby mode, press MENU to display the menu settings.
(2) Turn the SEL/PUSH EXEC dial to select FRAME REC in m, then press the
dial (p, 219).
(3) Turn the SEL/PUSH EXEC dial to select ON, then press the dial.
(4) Press MENU to make the menu settings disappear.
The FRAME REC indicator appears.
(5) Press START/STOP to start frame recording. Your camcorder makes a
recording for about six frames, and returns to recording standby.
(6) Move the subject, and repeat step (5).
To cancel the frame recording
Perform either of the following:
Set FRAME REC to OFF in the menu settings.
Set the POWER switch to the position other than CAMERA.
Note
The remaining tape time is not indicated correctly if you use this function continuously.
When using the frame recording function
The last recorded cut is longer than other cuts.
74