Making your own titles
You can make up to two titles and store them in your camcorder. Each title can have up
to 20 characters.
(1) In CAMERA or VCR/PLAYER mode, press TITLE.*
(2) Turn the SEL/PUSH EXEC dial to select [_, then press the dial.
(3) Turn the SEL/PUSH EXEC dial to select CUSTOM1 SET or CUSTOM2 SET,
then press the dial.
(4) Turn the SEL/PUSH EXEC dial to select the column of the desired character,
then press the dial.
(5) Turn the SEL/PUSH EXEC dial to select the desired character, then press the
dial.
(6) Repeat steps (4) and (5) until you have selected all characters and completed
the title.
(7) To finish making your own titles, turn the SEL/PUSH EXEC dial to select SET,
then press the dial. The title is stored in memory.
(8) Press TITLE to make the title menu disappear.
1
TITLE
A
2
3
rnLE SEt
CUSTOM1SE_
[_4 cvST°M2$E_
rI*LE SEt PI
E_TLE_E_
4 @
|
6
T_E SEt P_
O IIL_YY.........._!
KC_0 Agl 0 E÷ I
[_]aRSIAg[_o I+g21
uvwxY {,{_?g_ ST
ITnLI _B
@
_lJ 6_ 9 _.:
pQaN _ _}_u _+p2_
uvwx¥ A_O_ ESEr]
@
lnL_ S_T P_
S..........................
_LM _ ÷
A_OOA
O
O
* Modes on the POWER switch vary depending on models (p. 16).
77
To Next Page
Loading...
