Superimposing a still image in the" Memory Stick" on an image
- MEMORY MIX
Before operation
Insert a" Memory Stick" containing still images into your camcorder.
(1) Set the POWER switch to MEMORY. Make sure that the LOCK switch is set to
the left (unlock) position.
(2) Press MEMORY MIX.
The first recorded image appears in the bottom-right corner of the screen as a
thumbnail image. The last image that is used in MEMORY MIX will be
displayed next time.
(3) Press MEMORY+/ to select the still image you want to superimpose.
: To see the previous image
+ : To see the next image
(4) Turn the SEL/PUSH EXEC dial to select the desired mode.
The mode changes as follows:
M. CHROM ,,-+ M. LUMI ,,-+ C. CHROM
(5) Press the SEL/PUSH EXEC dial.
The still image overlaps with the picture on the screen.
(6) Turn the SEL/PUSH EXEC dial to adjust the effect.
M. CHROM
M. LUMI
C. CHROM
g_
O
The degree of the blue areas in the still image which is to be
swapped with a moving picture
The brightness of the area in the still image which is to be
swapped with a moving picture
The degree of the blue areas in the moving picture which is 8
to be swapped with a still image
g
The fewer bars there are on the screen, the stronger the effect becomes.
(7) Press PHOTO deeply to strut recording.
The image displayed on the screen will be recorded on a" Memory Stick."
Recording is complete when the bar scroll indicator disappears.
143
To Next Page
Loading...
