Connecting y.our camcorder to your
computer uszng the USB cable (madnt0sh)
When connecting to a computer using the USB cable
You must install a USB driver onto your computer in order to connect the camcorder to
the computer's USB connector. Tile USB driver can be found on the CD-ROM supplied,
along with the application software required for viewing images.
OS:
Mac OS 8.5.1/8.6/9.0/9.1/9.2 or Mac OS X (vl0.0/vl0.1)
Standard installation is required.
However, note that upgrade to Mac OS 9.0/9.1 should be used for the following
models:
iMac with the Mac OS 8.6 standard installation and a slot loading type CD-ROM drive
iBook or Power Mac G4 with the Mac OS 8.6 standard installation
Others:
The USB connector must be provided as standard.
QuickTime 3.0 or later must be installed to play back moving pictures.
Notes
• Operations are not guaranteed for the Macintosh environment if you connect two or
more USB equipment to a single computer at the same time, or when using a hub.
• Some equipment may not operate depending on the type of USB equipment that is
used simultaneously.
• Operations are not guaranteed for all the recommended computer environments
mentioned above.
_/W/_
0
0
0
3
205
To Next Page
