Types of trouble and how to correct trouble
Symptom Cause and/or Corrective Action
Easy Dubbing does not function. *_) • Your VCR and/or video camera recorder is not set
Digital program editing to a tape
does not function. *a
Digital program editing to a
"Memory Stick" does not function. *a
The Remote Commander supplied
with your camcorder does not
work. .4}
correctly.
"_ Make sure the input selector of the VCR is set to LINE.
Also, make sure the power switch of the video camera is
set to VTR/VCR (p. 99).
• The IR SETUP code or PAUSE MODE is not set correctly.
"_ Select the correct IR SETUP code and PAUSE MODE,
according to your VCR. Then confirm VCR operation
with the IR TEST function (p. 99).
• The input selector on the VCR is not set correctly.
"_ Check the connection and set the input selector on the
VCR again (p. 107).
• Your camcorder is connected to DV equipment of other
than Sony using the i.LINK cable.
"_ Set it to IR (p. 107).
• You have attempted to set a program on a blank portion of
the tape.
÷ Set the program again on a recorded portion (p. 115).
• Your camcorder and the VCR are not synchronized.
"_ Adjust the synchronization (p. 113).
• The IR SETUP code is incorrect.
"_ Set the correct code (p. 1Ol).
• PB MODE is set to II|mgm in the menu settings. .3/
"_ Set it m AUTO (p. 215).
• Setting program on a blank portion of the tape is
attempted.
÷ Set the program again on a recorded portion {p. 156).
• COMMANDER is set to OFF in the menu settings.
÷ Set it m ON (p. 222).
• Something is blocking the infrared rays.
"_ Remove the obstacle.
• The batleries are inserted with + and incorrectly
matching + and inside the battery compartment.
"_ Insert the batteries correctly (p. 264).
• The batleries are dead.
"_ Insert new ones (p. 264).
(continued on the following page)
229
To Next Page
Loading...
