4 Operation
Checks and tasks before daily use
Component
Course of action
Panes of glass (variant)
Perform a visual inspection for integrity.
Make sure they are clean (also free of ice).
Handholds
Check for secure mounting.
Maintenance lids
Check the close function and close.
Battery hood
Make sure that there are no unused bores in the
battery hood.
Battery door
Perform a visual inspection for integrity and defor-
mation.
Check that the interlock is in good condition and is
working correctly.
Check the close function.
Close.
Battery
Check that the interlock is in good condition and is
working correctly.
Lock the battery.
Ensure that the battery is approved for use in
potentially explosive areas.
Battery male connector and plug connec-
tion
Inspect the battery male connector and the plug
connection for moisture or any foreign objects that
may have become lodged and remove as necessary,
e.g. using compressed air.
Perform a visual inspection for integrity and
deformation.
Check the contacts.
Have damaged battery male connectors replaced by
the authorised service centre.
Coupling pin, tow coupling (variant)
Make sure that only a coupling pin that is ap-
proved for use in potentially explosive areas is used.
Perform a visual inspection for deformation and wear
(for example: bent, torn, broken).
Check the securing bush in the counterweight for
integrity and to ensure that it is working correctly.
Check that the linchpin is present and working
correctly (chain, rope, split pin).
Labelling, adhesive label
Check that labels are present and intact/legible.
Replace damaged or missing adhesive labels in
accordance with the section entitled "Labelling
points".
Driver's s
eat, seat belt
Check the
integrity and function.
92 5
6368011531 EN - 06/2019 - 02
To Next Page
Loading...
