Operation 4
Checks and tasks before daily use
Component
Course of action
Lighting, warning units
Check the integrity and function.
Check the setting of the warning zone light.
Antistatic belt (3), corona electrode (4)
(See the following illustration.)
Perform a visual inspection for integrity.
Ensure cleanliness.
Make sure that the antistatic belt(3) is still long
enough to touch the ground in all situations.
The discharge wires of the corona electrode (4)
must not touch the ground. The wires discharge the
energy to the air.
3
4
Antistatic belt and corona electrode
Depending on the tyres used, the truck
is fitted with one or more antistatic belts (3)
and/or with a corona electrode (4). These
components ensure that the truck cannot
charge statically.
– Do not use the truck if
there is any damage
or defects.
– In this case, contact your authorised service
centre.
Any other necessary tasks are summarised
under their own headings, e.g. adjusting the
driver's seat.
DANGER
Insufficient explos
ion protection
carries a risk of expl
osion!
If the explosion-p
rotection compo-
nents are defective
or no longer pre-
sent, do not oper
ate the truck in poten-
tially explosi
ve areas.
– Notify the auth
orised service
centre.
563
68011531 EN - 06/2019 - 02 93
To Next Page
Loading...
