4 Operation
Traction
contour and be damaged or torn off. Examples
of these components are:
• An unfolded roof panel in the driver's cab
• Open cab doors
Condition of the roadways
Roadways must be sufficiently firm and even.
The surface must be free from contamination
and fallen objects.
Drainage channels, level crossings and
similar obstacles must be evened out and,
if necessary, ramps must be provided so that
trucks can drive over these obstacles with as
few bumps as possible.
Take note of the load capa
city of manhole
covers, drain covers etc
.
There must be sufficient distance between the
highest points of the truck or the load and the
fixed elements of the surrounding area. The
height is based on the overall height of the lift
mast and the dimensions of the load; see the
chapter entitled "Technical data".
Rules for roadways andtheworkingarea
It is only permitted to drive on routes autho-
rised for traffic by the operating company or its
representatives. Traffic routes must be free
from obstacles. The load may be set down and
stored only in the designated locations. The
operating company and its representatives
must ensure that unauthorised third parties do
not enter the working area.
NOTE
Please observe the definition of the following
responsible person: "operating company".
Hazard areas
Hazard areas on roadways must be marked
by standard traffic signs or, if necessary, by
additional warning signs.
138
56368011531 EN - 06/2019 - 02
To Next Page
Loading...
