4 Operation
Handling loads
shake function moves the fork carriage quickly
up and down via the "Lifting" function.
This function may only be used for a limited
load and must not be used with a full nominal
load.
Maximum permissible load for the shake
function:
• Maximum 30% of the nominal lo
ad. If an
attachment is being used, it
s weight must
be subtracted from this valu
e.
NOTE
The weight of an attachment can be seen on
its nameplate.
Operation
To activate the shake function:
– Move the corresponding operating device
for the "Lifting" function over the zero
position four times in quick succession.
The fork carriage moves as normal. The
shake function is active after the fourth time
the operating device is moved.
– Continue to move the operating device back
and forth.
The fork carriage moves up and down more
quickly and more jerkily.
The intensity of the shaking is controlled via
the vigour with which the operating device is
moved. The more vigorously and frequently
the operating device is moved, the more
intense the shaking is.
NOTE
After the function has been activated, the
driver has two seconds to start the shaking.
If the two seconds elapse without the shake
function being used, the shake function is
deactivated again.
200
56368011531 EN - 06/2019 - 02
To Next Page
Loading...
